A6 Quattro Sedan V6-3.2L (BKH) (2005)
/Page-3508001.png)
Fluid - A/T: Service and Repair
ATF Level, Checking and Correcting
ATF level, checking and correcting 09L, 6 Speed AWD, A/T
Special tools, testers and auxiliary items required
^
Vehicle diagnostic, testing and information system VAS5051
^
Drip tray for workshop hoist VAS 6208
^
ATF charging device V.A.G 1924
^
Safety goggles
Test conditions
^
Transmission must not be in emergency running (backup) mode.
^
Vehicle must be level (horizontal).
^
Selector lever in position "P", engine idling.
^
Air conditioner and heating system switched off.
^
Vehicle diagnostic, testing and information system VAS5051 connected up; vehicle self diagnosis and vehicle system "02 - Gearbox electronics"
selected.
^
The ATF temperature at the beginning of the test must not be higher than 30° C. If necessary, first allow the transmission to cool down.
Note:
^
The ATF temperature is taken from the reading on the vehicle diagnostic, testing and information system VAS5051.
^
The ATF level will vary according to the ATF temperature.
^
If the ATF level is checked when the ATF temperature is too low, this will result in overfilling.
^
If the level is checked when the ATF temperature is too high, this will result in underfilling.
^
Both overfilling and underfilling have a detrimental effect on the functioning of the transmission
^
Use only the correct type of ATF (available as a replacement part) for the planetary gearing in automatic transmission 09L. Other oils cause
malfunctions and/or failure of the transmission.
