A6 Quattro Sedan V6-3.2L (BKH) (2005)
/Page-3596001.png)
Shifter A/T: Procedures
Selector Mechanism, Checking
Selector mechanism, checking 09L, 6 Speed AWD, A/T
^
It should not be possible to operate the starter while the selector lever is in position "S", "D", "R" or in the "Tiptronic gate".
^
When traveling at speeds above 5 km/h and shifting into selector lever position "N", the solenoid for the selector lever lock must not engage and
block the selector lever. The selector lever can be shifted into a driving gear.
^
When traveling at speeds below 2 km/h (almost stationary) and shifting into selector lever position "N", the solenoid for the selector lever lock
should only engage after about 1 second. Selector lever cannot be shifted out of "N" position until brake pedal is depressed.
Selector lever in "P" position and ignition switched on:
-
Do not depress brake pedal.
^
Selector lever is locked and cannot be shifted out of "P" position. Shift Lock Solenoid N110 blocks selector lever.
-
Press and hold brake pedal.
^
Shift Lock Solenoid N110 releases selector lever. It is possible to shift into a driving gear. Shift selector lever slowly from "P" position through
"R, N, D and S" and check whether the Transmission Range (TR) Display Y6 in the instrument cluster shows the correct selector lever position in
each case.
Selector lever in "N" position and ignition switched on:
-
Do not depress brake pedal.
^
After a short waiting time: Selector lever is locked and cannot be shifted out of "N" position without pressing the interlock button on the selector
lever handle. Shift Lock Solenoid N110 blocks selector lever.
-
Depress brake pedal.
^
Shift Lock Solenoid N110 releases selector lever. It is possible to shift into "D" position.
Selector lever in "D" position, ignition and lights switched on:
-
Shift selector lever into "Tiptronic gate".
^
The illuminated "D" symbol in the Selector Lever Transmission Range (TR) Position Display Y26 should go out and the "+" and "-" symbols
should light up.
^
The Transmission Range (TR) Display Y6 in the instrument cluster should change from "PRNDS" to "654321" when the selector lever is moved
into the "Tiptronic gate".
If specifications are not attained:
-
Adjust selector lever cable.
-
Check ignition key removal lock.
