A6 Quattro Sedan V8-4.2L (ART) (2000)
Pull in front bonded rubber bushing
-
To press in the bonded rubber bushings use G 294 421 A1 installation lubricant
-
Insert 3372/2 split bushings in 3372 installation device, Refer to Fig. A40-0092
-
Pull in bushing -A- until 3372/1 thrust piece is flush with upper edge of 3372 installation device.
Pull in front bonded rubber bushings
-
Raise pipe (3372) and remove bushing bushing (3372/2).
-
Replace bridge (3351/4) by thrust piece (3351/1) and then pull in bushings until they stop.
-
If the paint on the surface of the unit should be damaged, the surface should be protected against corrosion.