A6 Quattro Sedan V8-4.2L (ART) (2000)
/Page-7506005.png)
^
When folded in sequence, they form an overlapping crimp.
^
When folded simultaneously, they form a "B" crimp, as shown.
Closed-barrel terminals
Closed-barrel terminals have a round oval shaped crimp area. Crimping deforms the barrel using, for example, a nest and indent die, as shown.
Wire and Insulation Condition
The end of the wire, which is crimped to a terminal and carries the seal, must be free of damage and distortion.
-
Inspect for unevenness in the outer insulation that may prevent a proper seal, especially where a cable tie or other fastener has been used to secure the
harness.
If the wire has been installed too tightly and the insulation has been damaged
-
Make the repair in a different location, where the wire is not damaged.
Wire harness, repair
Note:
DO NOT use other procedures or matedals, other than those in VAS 1978, for wire harness repairs, specifically soldering, wire nuts, generic repair
kits, etc.
Always review Safety Precautions in VAS 1978 Instruction Manual prior to performing any wiring harness repairs.
If wiring harness repairs are required:
