A6 Quattro Sedan V8-4.2L (BVJ) (2007)
/Page-7082002.png)
‹› 25 Nm
8
Bolt
‹› 65 Nm
9
Coupling rod
‹› The coupling rod must be removed together with the stabilizer bar.
‹› Removing and installing, refer to => [ Coupling Rod and Stabilizer Bar ] See: Steering and Suspension/Suspension/Stabilizer Bar/Service and
Repair/Removal and Replacement/Rear Suspension/Coupling Rod and Stabilizer Bar.
10
Bolt
‹› 115 Nm plus an additional 90° turn
‹› Always replace after removal
‹› The hex head bolts may not be loosened when the springs are still installed.
‹› Tighten in a diagonal sequence using bolt => [ (Item 16) Bolt ]
‹› The threads in the body can be repaired using thread inserts made of wire according to DIN 8140 (Helicoil). Thread insert must be same length
as thread in body.
11
Bolt
‹› 85 Nm plus an additional 90° turn
‹› Always replace after removal
12
Tie Rod
13
Stone protection plate
14
Trapezoidal Control Arm
15
Bolt
‹› 55 Nm
16
Bolt
‹› 115 Nm plus an additional 90° turn
‹› Always replace after removal
‹› The hex head bolts may not be loosened when the springs are still installed.
‹› Tighten in a diagonal sequence using bolt => [ (Item 10) Bolt ]
‹› The threads in the body can be repaired using thread inserts made of wire according to DIN 8140 (Helicoil). Thread insert must be same length
as thread in body.
17
Support
18
Nut
‹› 95 Nm
‹› Always replace after removal
19
36 mm shim
