A6 Quattro Sedan V8-4.2L (BVJ) (2007)
1. Spindle (T10263/4) with nut (T10263/5)
2. Thrust piece (T40141). Conical side faces body.
3. Subframe
4. Bonded rubber bushing
5. Washer (T10205/15)
6. Washer (T10205/4)
7. Hydraulic cylinder (VAS 6178)
8. Spindle (T10263/4) with nut (T10263/5)
-
Press front bearing into subframe until stop.
Further installation is in reverse sequence to removal. Observe the following when doing so:
‹› Install coil springs or air springs, respectively, only if threaded connection of subframe has been tightened to specified tightening specification.
-
Installing coil springs. Refer to => [ Coil Spring ] See: Steering and Suspension/Suspension/Suspension Spring ( Coil / Leaf ) or air springs => [
Air Spring ] See: Steering and Suspension/Suspension/Suspension Control ( Automatic - Electronic )/Air Spring, respectively.
Tightening specifications. Refer to => [ Subframe, Stabilizer Bar and Coupling Rod Assembly Overview ] See: Rear Subframe/Service and Repair
-
On vehicles with air suspension, position vehicle on wheels. Refer to => [ Positioning Vehicle on Hoist and Wheels ] See: Steering and
Suspension/Suspension/Service and Repair/Procedures/Positioning Vehicle on Hoist and Wheels.
-
Tighten wheels. Refer to => Wheel and Tire Guide 44 Specifications.