A6 Quattro Sedan V8-4.2L (BVJ) (2007)
/Page-4015002.png)
‹› Different versions.
‹› Before installing new brake pads, thoroughly clean the brake calipers of contaminants (grease-free). When doing this, pay particular attention to
the cleanliness of the brake pad contact surfaces.
2 - Brake carrier
‹› Bolt to wheel bearing housing
3 - Ribbed bolt, 196 Nm
‹› If re-using, clean the ribs
‹› M14•1.5x 38
4 - Bushing
‹› Insert in brake caliper housing
5 - Guide pins, 30 Nm
6 - Cap
‹› Hook in the cable for wear indicator
7 - Brake disc
‹› Wear limit, refer to => [ Brakes System ] See: Specifications/Brakes System
‹› Must always be replaced together on both sides of axle
‹› Remove brake caliper before removing
‹› Coat contact surfaces between brake disc and wheel hub with Polycarbamide grease (G 052 142 A2).
‹› Allocation, refer to => [ Brakes System ] See: Specifications/Brakes System
‹› Thickness, refer to => [ Brakes System ] See: Specifications/Brakes System
8 - Wheel Bolts
9 - Bolt
‹› Tightening specification, 5 Nm
10 - Spring clamp
11 - Brake line connector to brake hose, 12 Nm
12 - Brake line
‹› Install in the brake caliper housing
‹› screwed together with brake hose, held against the hex nut of the brake hose.
‹› Hose must be installed free of twists
‹› Make sure that lugs are properly seated in grooves in bracket.
13 - Brake line connection to brake caliper, 17 Nm
14 - Bracket
‹› Bolt to brake caliper housing
