Audi Workshop Service and Repair Manuals

-

Remove hex nut - 2 -.

-

Remove hex bolt - 1 -.

-

Remove level control system sensor.

Installing

Installation is in reverse order of removal. Observe the following when doing so:

Guide retaining hook on the sensor bracket into the subframe.

Sensor lever must point toward front.

Tightening specifications. Refer to => [ Track Control Arm, Guide Link and Level Control System Sensor Assembly Overview ] See: Front
Suspension

-

Re-adapt control position. Refer to => [ Control Position, Programming ] See: Steering and Suspension/Suspension/Suspension Control (
Automatic - Electronic )/Testing and Inspection/Programming and Relearning/Control Position, Programming.

-

Perform headlamp basic setting.

-

Calibrate lane assist. Refer to => [ Calibration Procedure ] See: Maintenance/Alignment/Testing and Inspection/Component Tests and General
Diagnostics/Calibration Procedure