A6 Quattro Sedan V8-4.2L (BVJ) (2007)
/Page-4747007.png)
-
"J428 - Distance regulation calibration".
Now follow instructions on screen to perform adjustment.
-
Use upper screw - 1 - and lower screw - 2 - for precision adjustment in "Guided Fault Finding".
CAUTION!
The ACC adjustment is only accepted if "actuator test ended " is displayed in (VAS 5051/B).
-
Switch ignition off.
-
Disconnect Diagnostic Cable (VAS 5051/5A) connector from Data Link Connector (DLC).
-
Disconnect battery charger..
-
Install radar cover - 1 - on the bumper. Refer to Removal and Installation.
-
When installing radar cover - 1 -, make sure electrical wire does not slide over sensor lens.
