A6 Quattro Sedan V8-4.2L (BVJ) (2007)
‹› Marking - arrow B - is needed for installation of new bearing.
-
Install tools at subframe as shown in illustration.
1. Spindle (T10263/4) with nut (T10263/5)
2. Washer (T40033/1). Conical side faces body.
3. Subframe
4. Washer (T40033/2). Conical side faces body.
5. Sleeve (T40033/3)
6. Washer (T10205/4)
7. Hydraulic cylinder (VAS 6178)
8. Spindle (T10263/4) with nut (T10263/5)
CAUTION!
‹› Secure hydraulic press (VAS 6178) while pressing out.
‹› Bonded rubber bushing loosens abruptly. There is the risk of injuries by tools and bonded rubber bushing coming off!
-
Place drip tray for shop crane (VAS 6208) underneath.
-
Press out bonded rubber bushing and collect escaping oil.
Bonded rubber bushing, pressing in
-
Observe installation position of bonded rubber bushing.
-
Observe your marking - arrow B - on subframe - arrow A -.