A6 Quattro Sedan V8-4.2L (BVJ) (2007)
/Page-3677004.png)
^
Make sure that the markings on flange for driveshaft - arrow A - and for transmission/rear final drive - arrow B - line up.
^
If a new driveshaft is installed and the factory marking on the rear final drive flange is no longer visible, check radial run out at flange/driveshaft
and mark and adjust color marking at new driveshaft to new marking at flange/driveshaft.
-
Replace seals for driveshaft at transmission/rear final drive flange. Remove grease from sealing surfaces and adhere new seals.
-
Insert driveshaft and install with new bolts for CV joint.
-
Install mounting bolts - arrows - far enough that intermediate bearing can still be moved.
-
Tighten bolts - arrows - of driveshaft at rear final drive to tightening torque.
-
Tighten bolts - arrows - of front driveshaft to tightening torque.
-
Remove alignment fixture 3139.
