A6 Quattro Sedan V8-4.2L (BVJ) (2007)
/Page-3667002.png)
-
Loosen threaded connection - 1 - and remove both control arms - 2 - upward.
The slits in the wheel bearing housing must not be widened using a chisel or similar tool!
-
Tilt the wheel bearing housing to the side while pulling the drive axle pins out of the wheel hub.
-
Remove drive axle.
-
Insert both joint stubs of upper control arm - 2 - in wheel bearing housing and only insert bolt - 1 -.
‹› This step is necessary to avoid damage to suspension components when loosening and tightening the cap bolts.
