A6 Quattro Sedan V8-4.2L (BVJ) (2007)
Install Lower Seam Seal
NOTE:
-
To make installation easier, you can remove the entire door from the door hinges and install again without adjusting.
-
Clean adhesive surface before installing seal.
-
Adhesion surface must be free of dust and grease.
-
Clip seal into top.
-
Remove protective seal foil - 1 - beginning at bottom up to area of impression.
-
Attach seam seal up to area of impression.
-
Attach lower formed piece and bond on seam seal completely in lower area.
-
Remove remaining protective foil and bond on seal in upper area.
-
Screw in bottom of seal and tighten screw - 1 - to 1 Nm.
-
Press door cover rubber lip onto formed piece on bottom of - A - post.