A6 Quattro Sedan V8-4.2L (BVJ) (2007)
Windshield: Removal and Replacement
Preparing For Window Installation
Preparing For Window Installation
NOTE: If windshield flange was damaged during removal, paint structure should be repaired and if necessary, corrosion repair measures should be
taken.
For Undamaged Removed Windshield
-
Before reinstalling window, a new cover profile must be re-glued first.
-
When reusing an undamaged window, cut back smoothly residual adhesive sealing material on window and flange using electric cutter V.A.G
1561 and scraper V.A.G 1561/10 ; do not remove completely!
-
Residual material acts as a base for the new adhesive sealing material.
CAUTION:
-
Keep adhesive surface free of dirt and grease.
-
Only cut back adhesive surface shortly before installation.
-
Do not prime or use a cleaning solution on the adhesive surface.
With New Window:
-
Clean windshield in adhesion area using D 009 401 04 and prime using D 009 200 02 glass/paint primer.
NOTE: Part numbers are for reference only. Always check with your Parts Department for the latest part number information
Applying Primer
-
Apply primer - 2 - along circumference evenly and in one motion using applicator - 1 -.
-
Begin applying with saturated felt. Drying time approx. 10 minutes
-
Primer width dimension: Dimension - A - -approx. 20 mm
-
Apply primer in center of adhesive bead.
CAUTION: Ceramic application on window is not primer. It must be primed before the application of adhesive sealing material.
Dimensions For Adhesive Application
1
-
Adhesive sealing material
2
-
Primer
3
-
Window