A6 Quattro Wagon V6-2.8L (AFC) (1995)
Steering Gear: Service and Repair
Overhauling Power Steering Gear
Power steering gear repairing
CAUTION: Work place and individual parts must be kept completely clean.
NOTE: Power steering operates with power steering fluid, Part No. G 002 000, or equivalent. All parts marked with an asterisk (*) are included in the
repair kit and are to be replaced during repair. Moisten all O-rings, seals and other sealing parts with power steering fluid before installing. Do not
attempt to weld or straighten steering components
1
Banjo Bolt 20 Nm (15 ft lbs)
2
Balancing Line
3
Line
4
Banjo Bolt 20 Nm (15 ft lbs)
5
Right End Housing With Cylinder Pipe
Drive out with mandrel
Install O-rings and support ring and lubricate lightly with multipurpose grease before installing in steering housing
6
O-Ring*
Always replace
Dimensions: 34 x 2 mm
Installation position, refer to Fig. 6
7
Support Ring*
Always replace
Installation position, refer to Fig. 6
8
O-Rings*
Always replace
Dimensions: 30.3 x 2.4 mm
Installation position, refer to Fig. 6
9
Steering Housing/Steering Gear
After replacing, adjust toe. See: Alignment/Service and Repair
10 Hose Clamp
Always replace
Tightening, refer to Fig. 1