A6 Quattro Wagon V6-3.0L (AVK) (2002)
^
With engine cold (outside temp. approx. +20°C / 68°F) fluid must be at MAX level.
^
With engine warm (engine oil temp. 80°C / 176°F) fluid must be 10 mm above MAX level.
Eliminating air bubbles:
-
Test drive vehicle.
-
Switch ignition OFF.
-
Wait 1 minute, then open fluid reservoir and inspect for air bubbles.
If air bubbles are not visible:
^
No air is in the system (air in system is not cause for noise).
If air bubbles are visible:
-
Switch ignition OFF and allow vehicle to sit for at least 2 hours.
-
Check fluid level and add fluid if necessary.
-
Perform test drive again (ensure noise has been eliminated).
When procedure applies to vehicles within the New Vehicle Limited Warranty, use the table shown.