A6 Quattro Wagon V6-3.0L (AVK) (2002)
Steering Wheel: Initial Inspection and Diagnostic Overview
VAS 5051 Tester or VAG1551 Scan Tool (ST), Connecting
VAS5051 Tester Or VAG1551 Scan Tool (ST), Connecting And Selecting Functions
Test conditions
-
Battery voltage at least 11 V
-
Ground (GND) connections on engine and transmission OK
-
Fuses OK
-
Ground (GND) connections and Ground (GND) point for transmission OK
-
Check battery Ground (GND) strap and Ground (GND) strap between battery and transmission.
-
Switch ignition off.
NOTE: Data Link Connector (DLC) is located at bottom in driver-side footwell.
-
Unclip cover for Data Link Connector (DLC), located under driver's side knee bar, behind steering wheel (left-side).
-
Connect VAS5051 tester using adapter cable VAS5051/1. Alternatively, connect VAG1551 or VAG1552 Scan Tool (ST) with VAG1551/3
adapter cable to DLC.
WARNING!
-
During road tests, vehicle, test equipment must always be fastened to and operated from the rear seat by a second technician.
-
Observe safety precautions.
Indicated on display 1)
VAG - ON BOARD DIAGNOSTIC
HELP
1 - Rapid data transfer
2 - Blink code output
1) Operating modes 1 and 2 are displayed alternately
NOTE:
-
Switch ignition on.
-
Switch on printer by pressing PRINT button (indicator lamp in button lights up).
-
Press button -1- to select "Rapid data transfer" operating mode 1.
Indicated on display