A6 Quattro Wagon V6-3.0L (AVK) (2002)
Steering Wheel: Scan Tool Testing and Procedures
Output Diagnostic Test Mode (DTM) (Function 03)
Output Diagnostic Test Mode
NOTE:
-
Output Diagnostic Test Mode is only possible when vehicle is stationary and engine is not running!
-
If a malfunction is detected during output Diagnostic Test Mode (DTM), possibly Find and repair malfunction cause.
In the function "output Diagnostic Test Mode (DTM)" functions of the system are checked.
Initiating output Diagnostic Test Mode:
-
Switch on ignition
-
Switch radio on
-
Press buttons -0- and -3-. This selects "output Diagnostic Test Mode (DTM)", function 3.
Indicated on display
Rapid data transfer
Q
03 - Output Diagnostic Test Mode
-
Press -Q- button to confirm input.
Indicated on display
Output Diagnostic Test Mode
->
Radio louder
The radio volume is increased audibly..
-
Press -> button.
Indicated on display
Output Diagnostic Test Mode
->
Radio quieter
The radio volume is decreased audibly.
-
Press -> button.
Indicated on display
Output Diagnostic Test Mode
->
Radio station search upward
The next station will be searched and displayed in combination center display.
-
Press -> button.
Indicated on display
Output Diagnostic Test Mode
->
Search mode radio station downward
The previous station will be adjusted again and will be displayed in combination center display.
-
Press -> button.
Indicated on display
Output Diagnostic Test Mode
->
Station buttons forward
Station buttons will be switched through in forward motion.
-
Press -> button.
Indicated on display