A6 Quattro Wagon V6-3.0L (AVK) (2002)
marked before removal, driveshaft must be installed in the same position.
Notes:
-
After disconnecting driveshaft from rear final drive, an additional balance washer (thick washer) that may be located between shim and bolt head
may not be reinstalled.
-
After removing drive shaft, always remove any remaining locking fluid from thread bores in the transmission drive flanges and the rear final drive.
-
Otherwise there is a possibility that the new bolts may get jammed when installed and shear when removed.
-
Cleaning can be performed with a thread suffer.
-
Replace drive shaft bolts (self-locking).
-
Replace oil seal at flange/driveshaft and tighten driveshaft.
-
Install exhaust system free of stress.
Tightening torques