A6 Quattro Wagon V6-3.2L (BKH) (2006)
Trunk / Liftgate Motor: Service and Repair
Rear Lid Drive Unit
1
Rear lid left drive unit
CAUTION!
There are different drive units, which can be recognized by their drive forks.
Some drive forks have a self-threading screw - 7 - installed into both halves of the fork. On other drive forks, the self-threading screw - 7 - is
installed into just one fork half.
The screws - 7 - have different tightening specifications.
‹› Roof panel trim removed, refer to.
‹› Loosen D-pillar trim in drive unit area or push carefully to side.
‹› Remove or install drive unit only when rear lid is completely open.
‹› Before removing driving unit, loosen lock nuts on eccentric bolts.
‹› Remove electrical connector - 2 -.
‹› Loosen lock nut on drive unit, refer to.
‹› Eccentric bolts must be loose in hinge arm hole.
‹› Release tension on eccentric bolts with a brief turn to the right, if necessary.