A6 Quattro Wagon V6-3.2L (BKH) (2006)
‹› Torque specification, 19 Nm
12 - Bracket
‹› Bolt to brake caliper housing
‹› Hook in brake line
13 - Bolt M 8x 16
‹› Tightening specification, 25 Nm
14 - Brake caliper housing
‹› When doing work, do not allow to hang from brake hose, rather suspend it from the body using bundling wire
‹› Except for "Brake pads, replacing", refer to => [ Front Brake Pads, 2FNR 42 AL Caliper ] See: Disc Brake System/Brake Pad/Service and
Repair/Removal and Replacement/Front Brake Pads, 2FNR 42 AL Caliper and "Front brake caliper, servicing", no other repairs should be
performed on brake caliper
‹› Install hose so it is not twisted
15 - Retaining spring
‹› Observe correct installed position.
‹› After hooking into both studs, the retaining spring must be pressed under the brake carrier. If improperly installed, the wear of the outer brake pad
cannot be adjusted, thereby increasing brake pedal travel.