A6 Quattro Wagon V6-3.2L (BKH) (2006)
Removing
Special tools, testers and auxiliary items required
‹› Hose clamps up to 25 mm (3094) or hose clamps up to 40 mm (3093)
‹› Commercial compressed-air gun with rubber end piece
‹› Cooling system tester (V.A.G 1274) (and corresponding adapter)
Removing
‹› Perform preparatory work for removing heater core.
-
Cover the floor mat in the center tunnel area at the left and right under the heat exchanger with a waterproof cover and absorbent paper.
-
Remove the holder - A - for the coolant pipe - D - and the holder - B - for the heat exchanger - C -.
-
Loosen the screw - G - at the clamp - E - for the coolant pipe - D -.
-
Remove the clamp - E -.
-
Place a container under the connector for the coolant pipe - D - at the heat exchanger.
-
Remove the coolant pipe - D - out of the heat exchanger.
-
Remove the holder - A - for coolant pipes - D - and - E -.