A6 Quattro Wagon V6-3.2L (BKH) (2006)
CAUTION!
‹› With the introduction of form-fitting clips - C - (with an angle of approximately 65°) on top of the A/C control head, modified instrument
panel center sections have also been introduced (can be detected by a vertical slot - D - in area of top mounting bracket.) If an A/C control
head with clips - C - should be installed in an instrument panel center section without this slot - D -, possibly it can only be removed after
removing the instrument panel center section (form-fit connection can only be disengaged via this slot from the front).
‹› Climatronic Control Module (J255) units which were installed at the beginning of 2006 with a panel colored " pearl-gray metallic", force-fitted
clips - B - are installed on the top, deviating from this however during the transition period, form-fitting clips - C - may also be installed at some
components, only form-fitting clips - C - are installed with the introduction of A/C control head units with a panel colored "Nero".
Removing on a vehicle with a production date as of beginning of 2006
-
Grasp under Climatronic Control Module (J255) - B - and carefully pull Climatronic Control Module (J255) out of center console (A/C control
head with a panel colored "pearl-gray metallic"), if it cannot be disengaged from the instrument panel center section, remove center instrument
panel vent