A6 Quattro Wagon V6-3.2L (BKH) (2006)
/Page-5893006.png)
-
Remove the screws - B - (left and right at the center tunnel) and flip back the bracket - A -.
-
Remove the A/C unit.
Installing
Installation is carried out in the reverse order, when doing this note the following:
‹› When inserting the A/C unit, be careful of the cables to the control motors and the seals. They must not be pinched or damaged.
‹› Check all seals and replace if necessary.
‹› Connect the coolant hoses to the heat exchanger at the correct side.
‹› Secure all hose connections with standard hose clamps or clips as used in series production, or approved replacement parts.
-
Install the A/C unit.
-
Install instrument panel central tube (crossmember).
‹› In model year 2008, there is a rolling change in the threading at the screw points of the air distributor housing to the central tube of the instrument
panel (the cast metal inserts have been eliminated, the screws go directly into the plastic), ensure the proper screw version during installation.
-
Install the holder between the A/C unit and the central pipe of the instrument panel.
-
Flip the bracket- B - to the center tunnel and install the screws - B - (left and right at the center tunnel).
