A6 Quattro Wagon V6-3.2L (BKH) (2006)
Headlamp Control Module: Service and Repair
HID Headlamps with Dynamic Cornering Light, A6 and S6, Through May 2008
High-Intensity Gas Discharge Lamp Control Module
Removing
CAUTION!
Danger to life due to high voltage.
‹› Usage and safety information for gas discharge headlamps. Refer to=> Electrical System General Information 94.
-
With ignition switched off, disconnect battery Ground (GND) wire. Refer to=> [ Battery, Disconnecting and Connecting ] See: Starting and
Charging/Battery/Service and Repair/Battery.
-
Remove headlamp. Refer to=> [ Headlamp ].
-
Remove screws - arrows -.
-
Pull High-intensity Gas Discharge Lamp Control Module off from headlamp housing.
Installing
‹› Tightening specification. Refer to=> [ HID Headlamps Assembly Overview, A6 and S6, through May 2008 ] See: Headlamp/Service and
Repair/Removal and Replacement/HID Headlamps Assembly Overview, A6 and S6, Through May 2008.
Install in reverse order of removal, observing the following:
-
Check seal between High-intensity Gas Discharge Lamp Control Module and headlamp housing.
-
Install headlamp. Refer to=> [ Headlamp ].
-
Connect battery. Required actions => [ ] See: Starting and Charging/Battery/Service and Repair/Battery.
-
Adjust headlamps after installing.