A6 Quattro Wagon V6-3.2L (BKH) (2006)
Headlamp Igniter Module: Service and Repair
Ignition Coil For Gas Discharge Lamp, Removing and Installing
Ignition Coil For Gas Discharge Lamp, Removing And Installing
CAUTION:
-
HIGH VOLTAGE:
-
Always disconnect negative ( - ) battery terminal prior to working on parts of HID headlamp components marked with yellow "HIGH
VOLTAGE" warning symbols.
Removing
-
With ignition switched off, disconnect battery Ground (GND) wire.
Left headlamp - vehicles with 6-cyl. Gasoline engine:
-
Remove reservoir for power steering.
Right headlamp - vehicles with 6-cyl. Gasoline engine:
-
Remove air filter housing.
Right headlamp - vehicles with 4.2l MPI engine:
-
Remove air filter housing.
Right headlamp - vehicles with 4.2l FSI engine:
-
Remove air filter housing.
All:
-
Release securing guides - arrows - and remove headlamp housing cover.
-
If present, pivot securing clip - 1 - for electrical harness connector to side.
-
Rotate ignition coil - 2 - for gas discharge lamp counter-clockwise - arrow -.
-
Disconnect harness connector - 3 - at ignition coil for gas discharge lamp.
-
Remove ignition coil for gas discharge lamp.
Installing
Installation is performed in reverse order of removal, noting the following:
NOTE: Harness connector must only be connected with ignition coil installed.