A6 Quattro Wagon V6-3.2L (BKH) (2006)
/Page-2029003.png)
-
Insert wheel hub support (T10149) into engine/transmission jack (V.A.G 1383 A) and press wheel bearing housing far enough upward until
control position, dimension - a -, is obtained.
Control position
‹› Dimension - a - for vehicles with air suspension 384 mm
‹› Dimension - a - for Allroad vehicles with air spring 380 mm
CAUTION!
‹› Do not lift or lower vehicle when the engine/transmission jack stands below the vehicle.
‹› Do not leave engine/transmission jack below vehicle any longer than necessary.
Working after adjusting control position
-
Tighten respective bolts/nuts.
-
Lower wheel bearing housing.
-
Remove engine/transmission jack under vehicle.
-
Remove wheel hub support (T10149).
-
Connect air line - 1 - to the air line connector - 2 -.
-
Install bolt - 1 -.
