A6 Quattro Wagon V6-3.2L (BKH) (2006)
-
Remove the screws - arrows - and electronics box cover from the electronics box.
-
Remove the Engine Control Module (ECM) Power Supply Relay (J363) - 3 - from the electronics box.
If the manufacturers test box is being used, perform the following step.
-
Connect the Test Box 105 Pin (VAG1598/42) with Adapter Cable (1598/39-1) => Fuel Injection and Ignition 24 Diagnosis and Testing.
If the manufacturers test box is not being used, perform the following step.
-
Remove the Engine Control Module (ECM) (J623) => [ Engine Control Module, Replacing ] See: Relays and Modules - Computers and Control
Systems/Engine Control Module/Service and Repair/Engine Control Module, Replacing.
Checking voltage supply
-
Switch the ignition on.
Using a Multimeter, check the electrical harness connector terminals to the Engine Control Module (ECM) (J623) electrical harness connector
terminals for voltage.