audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Passive Occupant Detection System, Measures Required After an Accident|Page 17045 > < Passive Occupant Detection System, Measures Required After an Accident
Page 1
background image

Air Bag: Procedures
Airbag Units, Removing and Installing After an Accident

Airbag Units, Removing and Installing After an Accident

Special tools, testers and auxiliary items required

‹› Use a suitable vehicle tester such as the vehicle diagnosis, testing and information system (VAS 5051B).

‹› Airbag control module with airbag generation 8.* not 8.R can be used for up to two side airbag, side curtain airbag and/or belt tensioner

deployments.

‹› Airbag control module can be used with airbag generation 9.* and 9.R for up to two side airbag, side curtain airbag, driver's airbag, passenger's

airbag and/or belt tensioner deployments.

‹› After the third deployment, the malfunction display "Control module defect" appears.

Airbag control module must be replaced:

‹› with a driver's, passenger's airbag deployment "however not with airbag generation 9.* and 8.R" 

‹› After three side airbag, side curtain airbag, driver's airbag, passenger's airbag or belt tensioner deployments

‹› If housing is damaged

‹› If there is deformation on tunnel in 200 mm circumference around control module

Always replace the following:

‹› All deployed airbag units

‹› The Battery Switch-Off Relay (J655) or Battery Interrupt Igniter (N253) (equipment versions) 

Also with passenger airbag deployment:

‹› Instrument Panel

‹› Deformed passenger module supports (cannot be reformed)

‹› All sensors for front airbag on front end

‹› Remaining cross acceleration sensors if anchorage point is deformed in sensor region

Also with driver airbag deployment:

‹› Coil connector with slip ring

‹› All sensors for front airbag on front end

‹› Remaining cross acceleration sensors if anchorage point is deformed in sensor region

Also with side airbag deployment:

‹› Pressure sensors on deployed side

‹› Cross acceleration sensors on deployed side

‹› Cover

‹› Upholstery

‹› With foldable rear seat backrests: Side upholstery (if present)

‹› Remaining cross acceleration sensors if anchorage point is deformed in sensor region

Passive Occupant Detection System, Measures Required After an Accident|Page 17045 > < Passive Occupant Detection System, Measures Required After an Accident