A6 Quattro Wagon V6-3.2L (BKH) (2006)
1
Connector
Version I
‹› Disconnect the connector: Press the retainer - 3 - in the - direction of the arrow - and remove the crash sensor - 2 -.
Version II
‹› Disconnect the connector => [ Disconnecting the connector on the crash sensor - version II ].
2
Front side airbag crash sensor (pressure sensor)
‹› Removing
-
Disconnect the battery ground cable with the ignition switched on.
-
Remove door trim => [ Front Door Trim ] See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door Panel/Service and
Repair/Front Door Trim.
-
Remove the speaker in the door.
-
Reach the crash sensor - 2 - through the opening for the speaker and disconnect the electrical connector => [ (Item 1) Connector ].
-
Carefully remove the insulation far enough to reach the nuts - 4 -.
-
Remove the nuts and the crash sensor.
‹› Installing
To install, perform the steps used in removal in reverse order. When doing so, note the following: