A6 Quattro Wagon V6-3.2L (BKH) (2006)
-
Disconnect connector - A - from the Left Vent Temperature Sensor (G150).
-
Rotate the Left Vent Temperature Sensor (G150) - B - approximately 90° in direction of arrow.
-
Remove the Left Vent Temperature Sensor (G150) - B - from the A/C unit.
Installing
Installation is carried out in the reverse order, when doing this note the following.
-
Insert the Left Vent Temperature Sensor (G150) - B - on the proper side into A/C unit mount - D -.
-
Check the Left Vent Temperature Sensor (G150) for correct seating in mount - D -.
‹› The Left Vent Temperature Sensor (G150) - B - can only be inserted into mount - D - in one position, rotate 180° if necessary).
‹› An O-ring seal - C - can be installed so that the Left Vent Temperature Sensor (G150) fits without play in mount - D -.
-
Install the removed components again in reverse order.
-
Check the DTC memory for the Climatronic Control Module (J255) A/C control head and erase any faults displayed if necessary.