A6 Quattro Wagon V6-3.2L (BKH) (2006)
-
Disconnect connector - 6 -.
-
Remove bolts - 2 - (Qty. 2).
-
Remove cover from cushion:
-
Seat pan cover and upholstery, removing and installing (standard seat)
-
Seat pan cover and upholstery, removing and installing (memory seat, electric seat - standard seat)
-
Seat pan cover and upholstery, removing and installing (memory seat, electric seat- sport seat)
-
Seat pan cover and upholstery, removing and installing (S6-memory seat, electric seat)
-
Open the guide clip - 8 -.
CAUTION: Connectors - 3 - and - 7 - must not be separated.
-
Slide Seat Occupied Recognition Pressure Sensor G452 - 4 - sideways from retaining clip - 9 -.
2
-
Bolts
-
2.5 Nm
3
-
Connector on Seat Occupied Recognition Control Module J706
-
Must not be separated under any circumstances.
4
-
Seat Occupied Recognition Pressure Sensor G452
5
-
Pressure hose
6
-
Harness connector between service kit and seat wiring harness
7
-
Connector on Seat Occupied Recognition Pressure Sensor G452
-
Must not be separated under any circumstances.
8
-
Guide clip
9
-
Retaining bracket
Service kit, removing
-
Fold the cushion - 5 - upward.
NOTE:
-
The cushion is included as part of the service kit.
-
Clip - 4 - must not be separated.
-
The hard foam insert in the crease is not included in the service kit.
-
Remove clips - 2 - and - 3 - (Qty. 2).
-
Carefully pull seat occupied recognition mat - 1 - with upholstery - 5 - upward while guiding Seat Occupied Recognition Pressure Sensor
G452 and Seat Occupied Recognition Control Module J706 through seat pan without disconnecting connectors.
-
Remove the complete service kit.
CAUTION: The pressure hose and the Seat Occupied Recognition Mat - 1 - must not be kinked under any circumstances during
repairs.