A6 Quattro Wagon V6-3.2L (BKH) (2006)
Alignment: Procedures
Bringing Vehicle Into Initial Position For Alignment
Bringing vehicle into initial position for alignment
Suspension 1BA, 1BE, 1BR, 1BV, 1BK, 1BB
Note:
^
Due to the different alignment platforms, it may be necessary to raise the vehicle at the front axle so that it is possible to insert the spacer V.A. G
1925. After the vehicle is lowered, it should be bottomed out.
-
Insert spacer V.A.G. 1925 with appropriate adapter and remove both threaded spindles far enough that they just make contact on front bolts -
arrow - of subframe.
The vehicle may not be raised as a result of this!
The vehicle is now in initial position.
For all vehicle variants
The check of whether the present toe-in value of each wheel matches specification is performed in this position by the alignment program on the
alignment computer. If necessary, the toe-in should be corrected by adjusting the length of the tie rod.
Adjust Front Axle Toe in initial position.
The alignment program only shows correction if it is necessary to make one.