A6 Quattro Wagon V6-3.2L (BKH) (2006)
Alignment: Procedures
Rear Axle Camber, Adjusting
Rear Axle Camber, Adjusting
-
Remove nut - A - of threaded connection of wheel bearing housing/control arm, and screw on new nut until stop.
-
Adjust camber by turning eccentric bolt - B -.
Specified values for wheel alignment. Refer to => [ Wheel Alignment Specified Values ] See: Specifications.
‹› The maximum adjustment range is 90° to left or right of center position.
‹› If it is not possible to set the specified camber value by turning the eccentric bolt, there may be a deformation of the upper control arm. Aligning
upper control arm.
‹› For a better illustration, camber adjustment is shown with wheel removed.
-
Tighten nut - A - => [ (Item 3) Nut ] See: Sensors and Switches - Steering and Suspension/Sensors and Switches - Suspension/Suspension Control
Pressure Sensor/Switch/Service and Repair/Rear Suspension.
-
After tightening nut - A -, check camber value once more. Refer to => [ Wheel Alignment Specified Values ] See: Specifications.
Aligning upper control arm
-
Removing upper control arm. Refer to => [ Upper Transverse Link ] See: Suspension/Control Arm/Service and Repair/Removal and
Replacement/Rear Suspension/Upper Transverse Link.
-
Check dimension - A -.