A6 Quattro Wagon V6-3.2L (BKH) (2006)
‹› Tie rod may only be pressed off steering arm over tie rod ball joint pin ends or driven with a wooden or rubber hammer.
-
Place a cloth under separation point to absorb escaping hydraulic oil.
-
Remove banjo bolt - 1 - and secure the pressure hose on the wheel bearing housing.
-
Remove banjo bolt - 2 - with a bent open end wrench, for example Hazet 615.
-
The bolt - 3 - is located behind the banjo bolts - 1 - and - 2 - and, depending on the engine version, can be removed from the steering gear from
underneath.
‹› The illustration shows bolt - 3 - from inside.
-
Remove steering gear bolt - 3 -.