A6 Quattro Wagon V6-3.2L (BKH) (2006)
-
Remove guide link.
Installing
Installation is in reverse order of removal. Observe the following when doing so:
-
Remove adhesive residue at stub thread of guide control arm.
‹› Bonded rubber bushings can only be turned to a limited extent. Only tighten suspension bolts when vehicle is in curb weight or control position.
‹› Wheel bearing, lifting to curb weight position on vehicles with coil springs. Refer to => [ Wheel Bearing, with Coil Spring, Lifting to Curb Weight
Position ] See: Wheel Bearing/Service and Repair/Procedures/Front Suspension/Wheel Bearing, with Coil Spring, Lifting to Curb Weight Position
‹› Wheel bearing, lifting to control position on vehicles with air suspension. Refer to => [ Wheel Bearing, with Air Suspension, Lifting to Curb
Weight Position ] See: Wheel Bearing/Service and Repair/Procedures/Front Suspension/Wheel Bearing, with Air Suspension, Lifting to Curb
Weight Position
Tightening specifications. Refer to => [ Track Control Arm, Guide Link and Level Control System Sensor Assembly Overview ] See: Sensors and
Switches - Suspension/Suspension Control Pressure Sensor/Switch/Service and Repair/Front Suspension
-
Install wheel.
-
On vehicles with air suspension, position vehicle on wheels. Refer to => [ Positioning Vehicle on Hoist and Wheels ] See: Service and
Repair/Procedures/Positioning Vehicle on Hoist and Wheels.
-
Tighten wheel.