A6 Quattro Wagon V6-3.2L (BKH) (2006)
‹› Removing and installing, refer to => [ Wheel Bearing Unit ] See: Wheel Bearing/Service and Repair/Removal and Replacement/Front
Suspension/Wheel Bearing Unit
7
Wheel hub
‹› Ejecting and pressing in, refer to => [ Wheel Bearing Unit, Servicing ] See: Wheel Bearing/Service and Repair/Removal and
Replacement/Front Suspension/Wheel Bearing Unit, Servicing
8
Bolt
‹› 200 Nm plus an additional 180° turn
‹› Always replace after removal
‹› Always note the tightening sequence when loosening or tightening the collar bolt, refer to => [ Drive Axle Outer Joint Collar Bolt, Loosening
and Tightening ] See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and
Repair/Procedures/Front Suspension/Drive Axle Outer Joint Collar Bolt, Loosening and Tightening
9
Bolt
‹› 45 Nm
‹› 50 Nm on the RS 6
10
Brake shield
11
Socket head bolt
‹› 10 Nm
12
Wheel speed sensor
13
Socket head bolt
‹› 8 Nm
14
Self-locking nut
‹› 110 Nm
‹› Always replace after removal
‹› After loosening threaded connection of track control arm to wheel bearing housing, adhesive residue must be removed on thread of linkage
stub.
15
Self-locking nut
‹› 110 Nm
‹› Always replace after removal
‹› After loosening threaded connection of guide control arm to wheel bearing housing, adhesive residue must be removed on thread of linkage
stub.
16
Control Arm
17
Guide Link
18
Cap bolt
‹› 80 Nm plus an additional 90° additional turn
‹› Always replace after removal
19
Double hex bolt