A6 Quattro Wagon V6-3.2L (BKH) (2006)
-
Remove bolt - 1 -.
-
Remove wheel bearing housing.
Installing
Installation is in reverse order of removal. Observe the following when doing so:
‹› Bonded rubber bushings can only be turned to a limited extent. Only tighten suspension bolts when vehicle is in curb weight or control position.
‹› Wheel bearing, lifting to curb weight position on vehicles with coil springs. Refer to => [ Wheel Bearing, with Coil Spring, Lifting to Curb Weight
Position ] See: Wheel Bearing/Service and Repair/Procedures/Rear Suspension/Wheel Bearing, with Coil Spring, Lifting to Curb Weight Position
‹› Wheel bearing, lifting to control position on vehicles with air suspension. Refer to => [ Wheel Bearing, with Air Suspension, Lifting to Curb
Weight Position ] See: Wheel Bearing/Service and Repair/Procedures/Rear Suspension/Wheel Bearing, with Air Suspension, Lifting to Curb
Weight Position
Tightening specifications. Refer to=> [ Wheel Bearing Housing, Wheel Bearing Unit, Shock Absorber Coil Spring
Assembly Overview ] See: Wheel Bearing Housing, Wheel Bearing Unit, Shock Absorber Coil Spring Assembly Overview
-
Install coil spring. Refer to => [ Coil Spring ] See: Suspension Spring ( Coil / Leaf ).
-
In vehicles with air spring suspension, charge air spring at rear axle. Refer to => [ Rear Axle Air Spring, Bleeding and Filling ] See: Suspension
Control ( Automatic - Electronic )/Air Spring/Service and Repair/Procedures/Rear Suspension/Rear Axle Air Spring, Bleeding and Filling.
-
Install wheel.
-
On vehicles with air suspension, position vehicle on wheels. Refer to => [ Positioning Vehicle on Hoist and Wheels ] See: Service and
Repair/Procedures/Positioning Vehicle on Hoist and Wheels.