A6 Quattro Wagon V6-3.2L (BKH) (2006)
-
Install brake disc, screw on brake caliper.
-
Install wheel.
-
On vehicles with air suspension, position vehicle on wheels. Refer to => [ Positioning Vehicle on Hoist and Wheels ] See: Service and
Repair/Procedures/Positioning Vehicle on Hoist and Wheels.
-
Tighten wheel.
-
Tighten collar bolt for outer joint of drive axle (only tighten when vehicle is standing on its wheels "danger of accident"). Refer to => [ Drive Axle
Outer Joint Collar Bolt, Loosening and Tightening ] See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft
Assembly/Service and Repair/Procedures/Front Suspension/Drive Axle Outer Joint Collar Bolt, Loosening and Tightening.
-
On vehicles with automatic headlamp range control system, perform basic setting of headlamps.
-
Adapt control position again on vehicles with air spring suspension. Refer to => [ Control Position, Programming ] See: Suspension Control (
Automatic - Electronic )/Testing and Inspection/Programming and Relearning/Control Position, Programming.
-
Perform vehicle alignment. Refer to => [ Vehicle Alignment Procedure Overview ] See: Alignment/Service and Repair/Procedures/Vehicle
Alignment Procedure Overview.
Alignment must take place on a VW/Audi recommended alignment stand.