A6 Quattro Wagon V6-3.2L (BKH) (2006)
-
Slowly loosen air line - 1 - from the line connector - 2 - and allow air pressure to escape. After the air pressure has escaped, remove the air line.
-
Seal both connections. Make sure that no dust particles enter connections.
-
Turn wheel hub far enough until one of the holes for wheel bolts is on top.
-
Install wheel hub support (T10149) with wheel bolt.
-
Insert wheel hub support (T10149) into engine/transmission jack (V.A.G 1383 A) and press wheel bearing housing far enough upward until
control position, dimension - a -, is obtained.
Control position
‹› Dimension - a - for vehicles with air suspension 384 mm
‹› Dimension - a - for Allroad vehicles with air spring 380 mm
CAUTION!
‹› Do not lift or lower vehicle when the engine/transmission jack stands below the vehicle.
‹› Do not leave engine/transmission jack below vehicle any longer than necessary.
Working after adjusting control position
-
Tighten respective bolts/nuts.
-
Lower wheel bearing housing.