A6 Quattro Wagon V6-3.2L (BKH) (2006)
Specified value: 1.5 ohms Max.
If the specification was not obtained:
-
Check the wiring for a short circuit to each other, Battery (+), and Ground (GND).
-
If necessary, repair the faulty wiring connection.
If no malfunction was found in the wiring and the resistance was OK:
-
Replace the Transmission Control Module (TCM) (J217). Refer to=> [ Transmission Control Module, Replacing ] .
-
Assembly is performed in the reverse of the removal.
1. Check the DTC memory. Refer to => [ Diagnostic Mode 03 - Read DTC Memory ] See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 - 09/Diagnostic Mode 03 - Read DTC Memory.
2. If necessary, erase DTC memory of the Transmission Control Module (TCM) (J217). => [ Diagnostic Mode 04 - Erase DTC Memory ] See:
Powertrain Management/Computers and Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 -
09/Diagnostic Mode 04 - Erase DTC Memory.
3. Generate readiness code. => [ Readiness Code ] See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Monitors,
Trips, Drive Cycles and Readiness Codes/Readiness Code.