A6 Quattro Wagon V6-3.2L (BKH) (2006)
-
Drive joint onto drive axle with plastic hammer until circlip engages.
-
Add specified quantity of grease to the inner joint. See table => [ Grease quantity and type ] See: Service and Repair/Removal and
Replacement/Front Suspension/Drive Axle with Peened Triple Roller Joint AAR 3300 i and 100 mm and Outer CV Joint Assembly Overview.
-
Slide protective boot onto the joint.
-
Make sure the protective boot is seated on the joint correctly.
-
Protective joint boot must fit in groove and on joint contour.
-
Tension clamps on outer joint. Refer to => [ Large and Small Clamps, Clamping on Inner or Outer Joint ] See: Service and
Repair/Procedures/Front Suspension/Large and Small Clamps, Clamping on Inner or Outer Joint.