A6 Quattro Wagon V6-3.2L (BKH) (2006)
Replacing spinning washer of wheel bearing with 85 mm diameter or 92 mm diameter
-
Carefully pry off old spinning washer - 1 - using a screwdriver.
-
Position new spinning washer on wheel hub.
-
Attach special tools as shown in figure.
1. Thrust piece VW 473
2. Assembly tool T40089/1 for wheel bearing with 85 mm diameter or assembly tool T40089/2 for wheel bearing with 92 mm diameter
3. Spinning washer
4. Wheel hub
5. Thrust plate VW 401
-
Press on spinning washer up to radius of wheel bearing hub using assembly tool T40089/1 or T40089/2 as shown in the illustration.
Note:
^
Spinning washer must be pressed on up to radius of wheel bearing hub.
Pressing wheel hub into wheel bearing with 85 mm diameter
-
When pressing in, pressure pad VW 511 may only lie against bearing inner race.