A6 Quattro Wagon V6-3.2L (BKH) (2006)
Installing upper rear lid trim
Installation is reverse of removal, but note the following:
Note:
Replace damaged spring clamps (Figure 34, -2-).
-
Ensure all rubber buffers (Figure 34, -1-) are present in trim.
-
Guide trim between rear lid side window frames.
-
Clip in trim at top first and then at sides.
Tighten bolts (Figure 35, -1-).
Tightening torque - 2 NM
Install rubber seal lip over leading edge on luggage compartment side trim.