A6 Sedan V6-2.8L (AHA) (1998)
Display Group 50
NOTE:
-
The A/C compressor is switched off during acceleration when the car is stationary or at slow speed.
-
At wide open throttle the A/C compressor is switched off by the Transmission Control Module (TCM) (via the kick down switch).
Continuation
If the displayed values are NOT OK:
-
Connect VAG 1598/22 test box to ECM harness connector.Refer to "Scan Tool Testing/Scan Tool Connecting and Initial Checks/Connecting
VAG 1598/22 Test Box" See: Testing and Inspection
-
Check wiring for open circuit, short circuit to B+ or short circuit to Ground between ECM/test box terminal 8 and either A/C control head -E87- or
Transmission Control Module (TCM).
If the wiring is OK:
-
Check function of A/C control head -E87-.
-
Carry out electrical testing of automatic transmission
-
Check readiness code. If Diagnostic Trouble Code (DTC) memory has been erased, or ECM was disconnected, generate new readiness code.
Refer to "Moniters, Trips and/or Drive Cycle (Readiness Codes)/Checking Readiness Code" See: Testing and Inspection
Refer to "Moniters, Trips and/or Drive Cycle (Readiness Codes)/Generating Readiness Code See: Testing and Inspection