A6 Sedan V6-2.8L (AHA) (1998)
![background image](/audi/a6_sedan/v6-2.8l_(aha)/Page-4264003.png)
-
Using multimeter with auxiliary wires from VAG 1594, measure resistance across terminals on valve.
Specified value: 10-18 ohms
If resistance is not as specified:
-
Replace solenoid valve.
Checking voltage supply of valves for camshaft adjustment
-
Disconnect harness connector from valve.
-
Connect LED tester VAG 1527 between engine ground and terminal 1 of connector (B+).
-
Crank starter for several seconds (engine can start).
LED in voltage tester must light up.
If LED does not light up, conduct the following tests:
-
Check fuse for valves for camshaft adjustment.
-
Check wiring from terminal 1 on 2-pin connector to fuse for continuity per wiring diagram.
-
Check fuel pump relay and signal to relay. See: Fuel Delivery and Air Induction/Fuel Pump/Fuel Pump Relay/Testing and Inspection
Checking signal to valves for camshaft adjustment
-
Disconnect harness connector from valve.