Audi Workshop Service and Repair Manuals > A6 Sedan V6-2.8L (AHA) (1998) > Powertrain Management | Relays and Modules - Powertrain Management | Relays and Modules - Computers and Control Systems | Throttle Valve Control Module <--> [Electronic Throttle Control Module] | Component Information | Testing and Inspection | Component Tests and General Diagnostics | Closed Throttle Position (CTP) Switch, Checking

Closed Throttle Position (CTP) Switch, Checking|Page 8272 > < Closed Throttle Position (CTP) Switch, Checking|Page 8270

Page 2

Replace Motronic Engine Control Module (ECM) -J220-.

Carry out adaptation of throttle valve control module to ECM.

Check readiness code. If Diagnostic Trouble Code (DTC) memory has been erased, or ECM was disconnected, generate new readiness code.

Refer to "Moniters, Trips and/or Drive Cycle (Readiness Codes)/Checking Readiness Code" See: Computers and Control Systems/Testing and
Inspection
Refer to "Moniters, Trips and/or Drive Cycle (Readiness Codes)/Generating Readiness Code See: Computers and Control Systems/Testing and
Inspection

Powertrain Management
Relays and Modules - Powertrain Management / Relays and Modules - Computers and Control Systems / Throttle Valve Control Module <--> [Electronic Throttle Control Module] / Component Information
Testing and Inspection / Component Tests and General Diagnostics / Closed Throttle Position (CTP) Switch, Checking
Page 8271

Closed Throttle Position (CTP) Switch, Checking|Page 8272 > < Closed Throttle Position (CTP) Switch, Checking|Page 8270