A6 Sedan V6-2.8L (AHA) (1998)
-
Reach into tank and disconnect fuel lines to suction jet pump -2- by releasing tabs -arrows-.
NOTE: For better illustration purpose the accumulator is shown without fuel tank.
Installing
Installation is the reverse of removal, however note the following:
NOTE: Do not bend the fuel level sensor during installation.
-
Connect harness connectors before installing fuel level sensor 2 into fuel tank.
-
On inside of fuel tank install fuel lines to suction jet pump -2- into fuel level sensor 2.
Tabs must engage.
-
Insert new seal for fuel level sensor 2 dry into opening for fuel tank.