A6 Sedan V6-2.8L (AHA) (1998)
Transmission Temperature Sensor/Switch: Service and Repair
Transmission Wiring Harness, Removing and Installing
TRANSMISSION WIRING HARNESS, REMOVING AND INSTALLING
Removing
Removing and installing valve body. Refer to Valve Body.
-
Using a small screwdriver, pry out retaining tabs on solenoid valve connectors, and pull off harness connectors -A- one after the other.
-
Disengage wiring harness from retainers -B- on side of valve body.
-
Turn valve body over, and disconnect connector from sensor for transmission RPM -1-.
-
Remove first retaining clip (arrow -A-) and unclip harness from second retaining clip (arrow -B-).
-
Disconnect connector -2- from solenoid valve 4 -N91-.
Installing
Installation is the reverse of removal.
-
When installing harness, connect harness connectors onto respective solenoid valves.
-
Clip wiring harness into retaining clips provided.
CAUTION: If not installed correctly, the wiring harness can be trapped when the valve body is installed.