A6 Sedan V6-2.8L (AHA) (1998)
Fold felt strip evenly over top and bottom edge of plenum chamber cover as shown.
-
Apply felt to bottom edge of cowl panel.
-
Trim felt as necessary so edges do not protrude beyond edge of cowl panel where panel meets windshield -A- or where panel will snap into
windshield groove -B-.
-
Reinstall cowl panel and retainers.
-
Reinstall wiper arms.
Tightening torque: 16 Nm (144 in. lb)
-
Apply felt to plastic tab at corner of fresh air intake -arrow-.
-
Reinstall plenum chamber cover (requires extra effort and care due to added thickness of felt).
When procedure applies to vehicles within the New Vehicle Limited Warranty, use the following:
Part Identifier:
6416
Labor Operation:
6414510 75 TU